Genesis GMSDB1512L Use and Care Manual download pdf (Page 6)

English

12" Sliding Compound Miter Saw

Operator’s Manual GMSDB1512L

• Keep the motor air slots clean and free of chips, dust, or other obstructions which may

impair the ﬂow of cooling air to the motor.

• Make sure all the saw’s adjustment handles are tight before cutting, even if the table

is positioned in one of positive stops. Do not forget to tighten the rear mounted bevel adjustment handle.

• Never apply lubricants to the blade when it is running.

• Never use saw blades rated for operation at less than 5,000 rpm.

• Never start the tool with the work piece against the blade.

• Allow the motor to attain full speed prior to starting the cut.

• Always keep the blade guards in place and use at all times.

• Never reach around or behind the saw blade.

• Never lock the switch in the “on” position.

• Never attempt to recut small pieces.

• Never cut ferrous metals or masonry. This miter saw is designed to cut wood and wood-

like products.

• Do not perform free-hand cutting operations. Hold the work ﬁrmly against the fence

and table. Use clamps to hold the work when possible.

• Long or wide work pieces should be properly supported.

• IMPORTANT: After completing the cut, release the power switch and allow the blade to

come to a complete stop before returning the saw to a raised position.

• Turn off the saw and allow the blade to completely stop before cleaning the blade

area or removing debris and off-cuts in the path of the blade. Coasting blades are dangerous.

• Turn off the saw and allow the blade to completely stop before removing or un-

securing the work piece, changing the work piece angle, or changing the angle of the blade.

• Never perform layout, assembly or set-up work on the saw table or work area while the machine

is running.

• Turn the machine “off” and disconnect the machine from the power source before

installing or removing accessories, before adjusting or changing set-ups, or when making repairs.

• Disconnect the machine from the power source and clean the work area before leaving the

machine.

• If any part of your miter saw is missing, damaged, or fails in any way, or any

electrical component fails to perform properly, shut off the switch and remove the plug from the power

source. Replace missing, damaged, or failed parts before resuming operation.

WARNING: Read and understand all warnings, cautions and operating

instructions before using this equipment. Failure to follow all instructions listed below

may result in electric shock, ﬁre and/or serious personal injury.

SAVE THESE INSTRUCTIONS

1 2 3 4 5 6 7 8 9 10 11 ... 71 72

No comments

Genesis GMSDB1512L Use and Care Manual Page 6