Genesis GMSDB1512L Use and Care Manual download pdf (Page 9)

English

UNPACKING AND CONTENTS

IMPORTANT: Due to modern mass production techniques, it is unlikely the tool is

faulty or that a part is missing. If you ﬁnd anything wrong, do not operate the tool until

the parts have been replaced or the fault has been rectiﬁed. Failure to do so could result

in serious personal injury.

CONTENTS IN PACKAGE

Description Q'ty Description Q'ty

UNPACKING

1. Remove all loose parts from the carton.

2. Remove the packing materials from around the saw.

3. Using the carrying handle (4) carefully lift the saw from the carton and place it on a level work surface.

4. The saw has been shipped with the saw head locked in the down position. To release the saw head push down

on the top of the saw head, pull on the lock knob (24), rotate it a quarter turn and let go, slowly raise the saw

head.

ASSEMBLY AND ADJUSTMENTS

WARNING: DO NOT connect your compound miter saw to the power source

until the machine is completely assembled, all necessary adjustments made, and you

have read and understand the entire operator’s manual.

WARNING: Be sure that the tool is switched off and unplugged from the power

source before performing any work on the tool. Failure to unplug the saw may result in

accidental start-up, causing possible serious personal injury.

Your saw comes from the factory fully adjusted and requires only minor assembly to prepare the miter saw for

operation.

MOUNTING THE SAW

WARNING: Always make sure the miter saw is securely mounted to a workbench

or an approved miter stand. Failure to heed this warning can result in serious personal

injury.

The compound miter saw should be permanently mounted to a ﬁrm supporting surface such as workbench. Four

bolt holes have been provided in the saw base for this purpose. Each of the four mounting holes should be bolted

securely using 3/8 in. machine bolts, lock washers and hex nuts (not included). After securely mounting the saw,

carefully check the workbench to make sure that no movement can occur during use. If any tipping, sliding, or

walking is noted, secure the workbench to the ﬂoor before operation.

MITER LOCK HANDLE (FIG 2)

To install the Miter Lock Handle (1), simply screw the threaded

end of Miter Lock Handle into the threaded hole in the control arm.

Turn clockwise to tighten.

DUST PORT & DUST BAG (FIG 3)

The saw has a 2-5/16" sawdust port (1) at the rear of upper blade

guard. A dust collection system can be attached to this port to help

remove sawdust from the work area.

A dust bag (2) is provided for use with your miter saw. It can

be installed over the sawdust port. Squeeze the two metal clips

to open the mouth of the bag and slide onto the sawdust port.

FIG 2

Saw Assembly 1

Miter Lock Handle 1

Dust Bag 1

Table Extensions 2

Hold Down Clamp 1

Allen Wrenches 3

Operator's Manual 1

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 71 72

Comments to this Manuals

No comments

Genesis GMSDB1512L Use and Care Manual Page 9

Comments to this Manuals